FREE Training!!!
IDX is offering training for Anybus communicators free of charge. The content that will be covered during the course will be:
- Introduction to Modbus
- The Modbus protocol
- Introduction to the RS232/ RS485 PTM
- Reading registers
- Writing registers
- The importance of timing parameters
- Practical session
When setting up an Anybus communicator, the difficult stage of the installation is getting the information required from the serial device to the Anybus communicator. Reading the information from the fieldbus (PROFIBUS, Devicenet,...) is usually a simple task of reading the correct registers (memory areas). Where most people come undone is setting up the parameters for the Modbus network since there is little knowledge on this fieldbus.
Our aim is to skill up our clients so that they can effectively use the Anybus communicator for their specific applications.